here's my ak pistol i made from a hammer bent flat and a romy g kit

I like it I had a .223 ak pistol but traded it off I want to get .223 ak rifle one of these days. I like it nice pistol. I'm curious about the grip and trigger where did you get those from never seen that. I like it

Very Cool! Did you form the reciever?

i found them, the hard part was getting them out of the block of aluminum they were stuck in

i wanted to muve the grip forward an inch to try to get the balance point moved a little rearward compared to the grip, so it wouldnt be so frt heavy. i orig wanted to just cut the trigger off and weld it on more forward. i kneew, because of the location of the pivot that it would then swing down as it went back, but seeing how much it actualt DID move down, i found it unaccaptable. so i made the alum grip and the actual trigger acts as a trigger bar pushing the sear back.

hammer bent from a flat as per the agi video and their jig that there are plans for on the dvd.

btw, the knurled screw on the bottom of the grip is a storage compartment for the cleaning kit, which includes the sight tool w/ screwdriver end. the screwdriver end can then be used to unscrew the screw behind the knurled screw on the grip to access the oil resivour (kinda like the kit in the grip of a FAL)

That project is just too **** cool!! I've got some Romy kits that I'm hoping to someday build, but they're just going to be standard Romy Gs when done. Your pistol is just ausome!

That project is just too **** cool!! I've got some Romy kits that I'm hoping to someday build, but they're just going to be standard Romy Gs when done. Your pistol is just ausome!

I think I need to start investing in some AGI videos so I can start to do some cool stuff like this I only know basics. that is a nice design.

thanks, guys !!:)